© 2012 ControlOMatic, Inc. Grass Valley, California, USA
MiniChlor Hot Tub and Spa Saltwater System
The MiniChlor has no buttons, no moving parts, and is very easy to install. The MiniChlor saltwater system spa chlorine generator works as a convection cell that produces sanitizer (either chlorine or bromine) with a micro-bubble action that causes water to enter the bottom part of the cell as the bubbles leave the top. The MiniChlor includes 6 levels of chlorine production, salt level indicator lights and automatic cleaning of the titanium plates.
- Pure Chlorination, up to 15 grams per day
- 6 Levels of Chlorine Production, no external timer needed
- Salt Level Indicator Lights
- Self Cleaning Reverse Polarity Technology built in
- Plug & Play! No Spa Modifications Required
- No Buttons, No Control Boxes, No Timers!
It can be a challenge to to keep the water in your spa or hot tub crystal clear and smelling nice. If you forget to add chlorine or bromine for a single day or the chlorine feeder runs out that could lead to spa problems. Due to the higher temperature of the water the chemical balance is critical to be continuously maintained to keep it safe. Proper spa maintenance leads to your spa being safe when you want to use it. Even if the water looks good you should measure the chemical balance before use. Spa chlorine generators can greatly reduce spa problems and spa maintenance as they continuously make chlorine (or bromine) every day so you don’t have to. The MiniChlor makes chlorine on a 6 hour cycle. Every 6 hours it starts making chlorine, and based on the power level it will turn off at some point in that 6 hours and remain in standby mode, then at the next 6 hours it will start again.
The MiniChlor is our most economical saltwater system spa chlorine generator and easiest to use. The only setting required is the power level and to set the level simply turn it on when it is out of the water and it will cycle through 6 light color combinations, simply put it in the water at the light combination corresponding to the power level you want. It will remember the power level even if the power is turned off.
MiniChlor 110
The MiniChlor 110 is designed for basic 110 VAC outlets that are within ten feet of the spa. The 110 VAC outlet must be GFI or GFCI protected. The 110 VAC GFI or GFCI protected outlet must have a weather protective cover to protect the power supply at the power source.
Requirements:
- Spas & Hot Tubs To 600 Gallons
- Chlorine production 15 grams per day
- 110 VAC Outlet That is GFCI Protected
- Weather Protection Required At Power Source
Included In Purchase:
- 15' Power low 5Vdc power cord
- Salt & Chlorine Test Strips, 10 tests each
- 1-Year Limited Warranty
- Owners Manual and cable clip
MiniChlor 220
The MiniChlor 220 requires a connection at the spa pack or inside the spa equipment area. The power supply includes 2 foot VAC power wires for connection into the Spa power pack. It is highly recommended to have a licensed electrician connect to the power source. The connector to the MiniChlor cell is watertight and the cell cable is 10 feet long.
Requirements:
- Spas & Hot Tubs To 600 Gallons
- 110 or 220 VAC supply that is GFCI protected
- VAC Connection into the spa pack
Included In Purchase:
- 10' Power Cord to chlorinator Cell
- Salt & Chlorine Test Strips , 10 tests each
- 1-Year Limited Warranty
- Owners Manual
- Cable clip
- 3 Stainless steel screws
